Klevacool™ Fridge Fan Remote Control
Klevacool™ Fridge Fan Remote Control
Wish you could see what your Klevacool™ fridge fans are doing from inside your van or RV?
With our Australian made Klevacool™ Remote Control, you can!
(Connects to Klevacool external fan control board)
Our new remote control has the following features:
See what your fans are doing at a glance with our multicoloured status LED.
Turn the fans on, off or set to automatic, simply by flicking a switch.
Mounted with 2 small stainless steel screws.
Simply connects to the Klevacool™ vent fan control board with a single cable.
Bright, clear front label makes for easy reading.
FREE POSTAGE AUSTRALIA WIDE FOR THIS ITEM!
Please read important notes at the bottom of this page before ordering!
Remote comes with a 3 meter lead as standard.
If you need more length, a 5 or 10 meter lead can be selected before adding to cart.
Our remote control is the perfect addition to our Klevacool caravan fridge fan systems!
The control cable is designed to simply clip in to the back of the remote & the other end clips into the remote port on our Australian made fan controller.
Turn your fans ON, OFF or leave in AUTO MODE, all from inside your van!
See what your fans are doing at any time, simply by observing the colour of the LED on the controller panel.
Only one simple cable to connect.
No power supply is required! The controller board supplies power to the remote.
The remote is fully tested before being sent to you.
12 months warranty.
The Klevacool remote adds convenience & control to your Klevacool Fridge Fan system.
Important Notes:
This Remote control is specifically designed to work with Klevacool external fridge fan systems that have the elctronic control board with a remote connection port. It will not work with early systems that use a thermo-switch or any other fridge fan system.
A 22mm (7/8”) hole will need to be drilled behind the remote, to allow the cable to be connected.
A paper template is supplied for hole marking.
One end of cable connects to rear of the remote
The other end of the remote cable connects to Klevacool control board. Simple!
A drilling template is provided to make mounting easy!
INCLUDED IN THE KIT:
1 x Klevacool remote control.
3 x stainless steel mounting screws (two required. One is a spare).
3 x screw cover caps (two required. One is a spare)
1 x cable 3 meters long. 5 meter cable can be selected when adding to cart.
Zipties to fasten cable where required.
Detailed installation instructions in full colour, including drilling templates & operation guide.
